Rheem RGPH-07EAMGR Furnace Error Codes

Single Stage Gas Furnace | Control Board: UTEC 1012-925

Not your model? View all Rheem models →

Disclaimer
This information is for reference purposes only and does not guarantee accuracy or completeness. Always consult your owner's manual and a licensed HVAC technician for diagnosis and repair. Any actions taken based on this information are at your own risk.

All Error Codes

Code Name Severity DIY?
1 Blink (2-sec pause) 1 Hour Lockout High ✓ Yes →
2 Blinks (2-sec pause) Pressure Switch Is Open High ✓ Yes →
3 Blinks (2-sec pause) Limit Switch Is Open High ✓ Yes →
4 Blinks (2-sec pause) Pressure Switch Shorted High ✗ Call a pro →
LED Off No Power to Control Board High ✓ Yes →
LED Steady On Normal Operation Info — →
Flame LED Rapid Blink Unexpected Flame Detected High ✗ Call a pro →
Flame LED Slow Blink Marginal Flame Sense Current Low ✓ Yes →

How to Read the Error Code

The Integrated Furnace Control (IFC) UTEC 1012-925 uses an "OK" LED to indicate system status. The LED blinks to indicate external faults: (1) blink followed by a 2 second pause indicates 1 hour lockout, (2) blinks indicates pressure switch is open, (3) blinks indicates limit switch is open, (4) blinks indicates pressure switch shorted. A separate yellow (amber) flame sense LED indicates flame current status: steady on means flame current is good, flashing means current is marginal.

About This Model

The Rheem RGPH-07EAMGR is a single stage gas furnace using the UTEC 1012-925 control board.